Contact us
Welcome to call
13715491170
Leave us a messageMessage
Technical Support
Your location:Home ＞ News ＞ Technical SupportSealing technology of PC board
Announcer:Haosu Time:2017-03-14
The original adhesive tape on the sun board. Used only for temporary protection plate edge is not resistant to aging, in the installation of the project, according to the size of the conference board, material code requirements must be installed in the seal plate end hole with engineering special tape, the original tape replaced. The special adhesive tape for installation should have good weather resistance and long-term use without losing its cohesiveness and mechanical strength.
Pay attention to the following points:
(1) Make sure the edges of the sheet are smooth.
(2)To blow all holes clean, the compressed air must be free of any impurities, dry.
(3) Make sure all the tape is covered completely with the profile and metal cover, and the end of the U shaped protective groove, and the exposed part should not be exposed after the installation.
(4) Check the adhesive tape before installation and final installation, and find the damaged adhesive tape must be replaced.
Pay attention to the following points:
(1) Make sure the edges of the sheet are smooth.
(2)To blow all holes clean, the compressed air must be free of any impurities, dry.
(3) Make sure all the tape is covered completely with the profile and metal cover, and the end of the U shaped protective groove, and the exposed part should not be exposed after the installation.
(4) Check the adhesive tape before installation and final installation, and find the damaged adhesive tape must be replaced.
Related news
- Requirements for cold bending of PC boar…2017-03-14
- Method for mounting PC board2017-03-14
- PC board installation precautions2017-03-14
- Storage and transportation of PC plates2017-03-14
- PC plate material properties2017-03-14
